1998 Buick Skylark Crankshaft position sensor

Tiny
GONZALES_MICHAEL02
  • MEMBER
  • 1998 BUICK SKYLARK
  • 6 CYL
  • 2WD
  • AUTOMATIC
  • 145,000 MILES
Where is the crankshaft position sensor on a 1998 Buick Skylark 3.1V6? The repair manual says its on the firewall side of the engine block but I really need to see a diagram of where exactly it is. Please post a diagram or give me a website for it please!
Thursday, August 11th, 2011 AT 5:06 PM

10 Replies

Tiny
SATURNTECH9
  • MECHANIC
  • 30,869 POSTS
I dont have a diagram there is two the 7x one is right front side of the engine and the 24x one is front side of engine.
Was this
answer
helpful?
Yes
No
Thursday, August 11th, 2011 AT 5:22 PM
Tiny
JDL
  • MECHANIC
  • 16,098 POSTS
The 24x sensor should be down by the crankshaft pulley. The 7x sensor is on the back side of engine block, down low, get at it from underneath the vehicle. My wiring showed 24x, so I would look for wiring connector around crankshaft pulley. I'll see if I can find a picture?
Was this
answer
helpful?
Yes
No
+1
Thursday, August 11th, 2011 AT 5:26 PM
Tiny
JDL
  • MECHANIC
  • 16,098 POSTS
Below is a picture for the 24x sensor. Passenger side down low, have to remove crankshaft pulley.
Was this
answer
helpful?
Yes
No
+1
Thursday, August 11th, 2011 AT 5:32 PM
Tiny
SATURNTECH9
  • MECHANIC
  • 30,869 POSTS
Thanks for the assist jdl have a great day.
Was this
answer
helpful?
Yes
No
Thursday, August 11th, 2011 AT 5:34 PM
Tiny
JDL
  • MECHANIC
  • 16,098 POSTS
Hey saturntech9 didn't see your post, before I started looking for info. Wasn't trying to butt in. Have a good day.
Was this
answer
helpful?
Yes
No
Thursday, August 11th, 2011 AT 5:34 PM
Tiny
SATURNTECH9
  • MECHANIC
  • 30,869 POSTS
No worries jdl were all on the same team here to help out the users better to give them too much help then not enough help.
Was this
answer
helpful?
Yes
No
+1
Thursday, August 11th, 2011 AT 5:39 PM
Tiny
GONZALES_MICHAEL02
  • MEMBER
  • 3 POSTS
Thanks for all the help guys! I really need a diagram for the 7x crankshaft sensor if possible. If not I will just have to figure it out.
Was this
answer
helpful?
Yes
No
Thursday, August 11th, 2011 AT 5:41 PM
Tiny
SATURNTECH9
  • MECHANIC
  • 30,869 POSTS
If it helps you any the 7X sensor has a yellow wire and a purple wire going to it. That should narrow down your search.
Was this
answer
helpful?
Yes
No
Thursday, August 11th, 2011 AT 7:15 PM
Tiny
GONZALES_MICHAEL02
  • MEMBER
  • 3 POSTS
Thank you very much. I know exactly where it is now. Thsnks for all the great help guys.
Was this
answer
helpful?
Yes
No
-1
Friday, August 12th, 2011 AT 3:24 PM
Tiny
SATURNTECH9
  • MECHANIC
  • 30,869 POSTS
Your welcome thats what were here for glad you found it.
Was this
answer
helpful?
Yes
No
Friday, August 12th, 2011 AT 3:37 PM

Please login or register to post a reply.

Sponsored links