Coolant and water light came on and stays on after changing the water and coolant

Tiny
VMICKEN@HOTMAIL.COM
  • MEMBER
  • 1997 SATURN SL1
  • 200,000 MILES
Changed the water and coolant, car is not overheating but the water light is flashing on the panel inside the car
Do you
have the same problem?
Yes
No
Thursday, December 8th, 2011 AT 2:36 AM

3 Replies

Tiny
RASMATAZ
  • EXPERT
Try checking the coolant temperature sensor-also try scanning the computer for code/s
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Thursday, December 8th, 2011 AT 2:41 AM
Tiny
DRCRANKNWRENCH
  • MEMBER
You may have a bad temp sensor or air in the cooling system. Bleed the system by filling it up with the heater on full hot. If you have a temp gauage you will have 2 temp sensors. You will be replacing the one that has only 1 wire.
Was this
answer
helpful?
Yes
No
Thursday, December 8th, 2011 AT 2:42 AM
Tiny
SATURNTECH9
  • EXPERT
Starting in 1996 the saturn S model went to one sensor for both the gauge and the computer with two wires. But the light flashing means your coolant level is low in the bottle. Check the level. Let me know what you find.
Was this
answer
helpful?
Yes
No
Thursday, December 8th, 2011 AT 3:31 AM

Please login or register to post a reply.

Related Coolant Flush Content

Coolant Drain and Refill
VIDEO
Coolant Drain and Refill
Instructional repair video
Cooling System Drain and Flush
GUIDE
Cooling System Drain and Flush
Your car's cooling system is designed to keep the engine from overheating while in operation. This is achieved through the use of engine coolant and a radiator which ...
VIEW MORE

Sponsored links