I have a 2

Tiny
ANONYMOUS
  • 1996 MITSUBISHI ECLIPSE
  • 180 MILES

I have a 2.4 eclipse and I don't have any signal coming from mycrank position sensor. I don't have any spark but I do have fuel. My crank sensor has power and ground. I have changed the ignition module and tested the cam sensor also I changed my coil packs. I can't seem to find anyone that can help. It will crank but the sensor will just not read the signal or something.

Tuesday, November 13th, 2012 AT 9:23 PM

1 Reply

Tiny
KHLOW2008
  • EXPERT
  • 41,940 POSTS

If the crank sensor is good and signals are not being read by the PCM, that would indicate a bad PCM. Did you test the crank sensor wire for continuity between the PCM?
Are you getting battery voltage at the ignition coils?

Please consider a donation to help us answer more questions.
Was this
answer
helpful?
Yes
No
Wednesday, November 14th, 2012 AT 12:17 PM

Please login or register to post a reply.

Related Ignition Coil Replace/Remove Questions

Help us by donating