At 70 mph my Tracker is running about 4,000 RPMs.

Tiny
PRUDEN_MARK@YAHOO.COM
  • 1996 GEO TRACKER

What should my rpms be? I do have a code of torque converter not locking up. What could be the problem and are the rpms right?

Do you
have the same problem?
Yes
No
Saturday, April 21st, 2012 AT 11:40 AM

1 Reply

Tiny
WRENCHTECH
  • EXPERT
  • 20,787 POSTS

Yes, the Converter not locking up is taking away overdrive or it is not shifting into high gear.

SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Saturday, April 21st, 2012 AT 12:55 PM

Please login or register to post a reply.

Related Engine Revs Up Questions

94 Geo Tracker. Runs Fine, When 1st Started. Begins To...

If Turned Off For A Short Time, Gas Pedal Has To Be Floored. Runs Very Doggily Until Revvs Built Up & Belches Black Smoke. If Turned Off...
Asked by Mack ·
1 ANSWER
1994
GEO TRACKER

Engine Is Revving On Its Own

What Might Be Causing My 1992 Geo Tracker To Hesitate And Rev Frequently Before Shifting After Turning And When First Starting Out With...
Asked by Michael Nunn ·
1 ANSWER
1992
GEO TRACKER

1990 Geo Tracker Engine Idles Irregularly

Engine Problem 1990 Geo Tracker 4 Cyl Four Wheel Drive Manual 210700 Miles When The Vehicle Is Parked We Get An Idle That Is Between...
Asked by theinkwell ·
2 ANSWERS
1990
GEO TRACKER

Engine Turns Over But Will Not Start

Recently Purchased 1996 Tracker That Was Run Hot. Pulled Head And Sent To Shop To Be Shaved And Valves Leak Tested. Valves Checked Good....
Asked by CBCC12 ·
1 ANSWER
1 IMAGE
1996
GEO TRACKER

Recommended articles