1995 Mercury Tracer Installing heater controls

1995 MERCURY TRACER
150,000 MILES • 1.9L • 4 CYL • 2WD • AUTOMATIC
Avatar
CB650THOMAS
  • MEMBER
  • 1 POST
There is no heater control in the car. How do I install one into the car? I don't see any pull cables. Is there any way I can get heat in the car without the unit? Need a defroster until I can get the unit. I can see the cables on each side of the console. What do they control and will I be able to use them at all?
Jan 25, 2014 at 1:01 PM
Advertisement
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Avatar
HMAC300
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 48,601 POSTS
there are two cables one is for heat look at pic an dthen look to see where yours is if the cable is broken ty movint it in opposite direction. temp control may be on drivers side under dash if you look
Images (Click to enlarge)
Attached Media
Attached Media
Jan 25, 2014 at 3:38 PM