1994 MITSUBISHI MIGHTY MAX
197,000 MILES
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
I sprayed degreaser on my engine, think I might of got something wet. First notion was maybe moisture in the dis cap, changed the cap rotor and wires, still having problem. The truck starts and runs, then putting it into gear and taking off does fine, when I start to stop I push in the clutch and put it into neutral I hear a clicking sound on the passenger side and the truck dies, starts right back up but keeps doing it when Im stopping. Is this the saftey switch?
Dec 17, 2012 at 7:32 PM
Advertisement
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Avatar
KHLOW2008
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 41,814 POSTS
Safety switch has nothing to do with engine stalling. It only controls the starting (starter cranking ) circuit. The idling speed is too low and if engine is misfiring, it would stall.

Dec 18, 2012 at 7:50 PM