Suspension/ Ball joints

1994 HONDA PRELUDE
156,600 MILES • 4 CYL • AUTOMATIC
Avatar
GINGY012
  • MEMBER
  • 86 POSTS
I was wondering how i would change the lower ball joints on my car? Any helpful tips or tools without an air compressor i can use to make it easier?
May 30, 2011 at 1:38 AM
Advertisement
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Avatar
CARADIODOC
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 34,308 POSTS
You need a ball joint press. There's nothing that requires compressed air. Air tools just make the job faster, that's all.
May 30, 2011 at 3:54 AM
Avatar
GINGY012
  • MEMBER
  • 86 POSTS
to get the ball joint in or out?
May 30, 2011 at 10:36 AM
Advertisement
Avatar
CARADIODOC
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 34,308 POSTS
Both. It's a press-fit. If you understand the procedure, you can often borrow the tool from an auto parts store that borrows or rents them.
May 30, 2011 at 10:06 PM