How to install ABS control module 1997 Ford.

Tiny
ANONYMOUS
  • MEMBER
  • 1994 FORD FIVE HUNDRED
  • 100,000 MILES
How to install abs control module 1997 ford ranger?

Monday, November 19th, 2012 AT 9:19 AM

1 Reply

Tiny
ASEMASTER6371
  • MECHANIC
  • 52,797 POSTS
REMOVAL

Disconnect the battery cables and remove the battery.

Wire Harness Connector And Anti-Lock Brake Control Module

Locate the ABS control module electrical connector in front and to the right of the battery tray. Disconnect the connector.
Remove the ABS control module-to-radiator support screw.
Slide the ABS control module to release the retaining tab and remove the module from the vehicle.

INSTALLATION
To install, reverse the removal procedure, noting the following:

Tighten the module-to-radiator support screw to6-8 Nm (53-71 inch lbs.).
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
+4
Monday, November 19th, 2012 AT 1:18 PM

Please login or register to post a reply.

Related ABS Module Replace/Remove Content

ABS Module Replacement Video
VIDEO
ABS Module Replacement Video
Instructional repair video
ABS and Traction Control Module Replacement
GUIDE
ABS and Traction Control Module Replacement
The ABS control module is used to monitor the wheel rotational speed and will send a signal to the ABS valve and motor pump to decrease or increase the brake line pressure...

Sponsored links