Cant get it to fire

Tiny
DAVIDC22
  • MEMBER
  • 1994 CHEVROLET S-10
  • 6 CYL
  • 4WD
  • AUTOMATIC
  • 196,000 MILES
Well I have a 94 s10 blazer 4x4 vin w and I just did a head job on it and replaced almost everything. Like injector, egr, distributor, knock sensors, exhaust, plugs, wires, but now it wont start
SPONSORED LINKS
Do you
have the same problem?
Yes
No
Tuesday, February 22nd, 2011 AT 2:28 PM

1 Reply

Tiny
MMPRINCE4000
  • EXPERT
Remove #1 plug and rotate engine by hand, place finger over #1 spark plug hole, when you feel air coming out look at timing marks on balancer and block, should be close to aligning, and rotor should be pointing at #1 plug wire on dist. Cap.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Tuesday, February 22nd, 2011 AT 2:52 PM

Please login or register to post a reply.

Related Knock Sensor Replace/Remove Content

VIEW MORE

Sponsored links