getting OBD codes from a 1993 Chrysler Concorde

1993 CHRYSLER CONCORDE

147,000 MILES

SPCAUDILL

MEMBER
1 POST
FOLLOW

You told a questioner about getting OBD codes from a 1993 Chrysler Concorde to cycle the key on an off 3 times and read the codes. Where do you read the codes? Does a light flash on the dash a certain number of times or what? Thank you.

Feb 27, 2012 at 10:14 PM

Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.

CARADIODOC

AUTOMOTIVE REPAIR CONTRIBUTOR
34,308 POSTS

Before '96 models, watch the Check Engine light flash. After about five seconds it will flash the digit number, there will be a short pause, it will flash the second digit, then there will be a longer pause before the next two-digit code flashes out. The last code will always be five flashes, short pause, five flashes. That's code 55 which just means "end of message".

On newer models the three-digit codes are displayed in the odometer readout.

Feb 27, 2012 at 11:22 PM

DRCRANKNWRENCH

AUTOMOTIVE REPAIR CONTRIBUTOR
3,380 POSTS

I am attaching instruction and code definitions which are numbered.

Images (Click to enlarge)

Feb 27, 2012 at 11:37 PM