TROUBLE CODE 27- injector output circuit not respondin

Tiny
WOODY863
  • MEMBER
  • 1992 DODGE DAKOTA
  • 80,000 MILES
Not sure what and/or code means or where to look to fix the engine is a 5.2L just bought the truck not real sure on the history, I do know it has a rebuilt trans, other than that the engine looks clean ( not dealer clean ).
SPONSORED LINKS
Do you
have the same problem?
Yes
No
Sunday, March 11th, 2012 AT 8:26 PM

3 Replies

Tiny
RASMATAZ
  • EXPERT
DTC 27 Injector #1 control circuit. Injector output driver does not respond properly to the control signal.

Check wiring back to the computer and injector driver circuit
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
+2
Sunday, March 11th, 2012 AT 8:41 PM
Tiny
KHLOW2008
  • EXPERT
Clear the code and retest. If problem comes back you wuold need to performs test to diganose the problem.

TEST NS-5A - REPAIRING FAULT "FUEL INJECTOR CONTROL CIRCUIT"

Turn ignition off. Disconnect injector No. 1 connector. Turn ignition on. Using DRB-II, actuate fuel system. Place DRB-II in voltmeter mode. Probe Dark Green/Orange wire in injector connector. If voltage is less than 10 volts, repair open Dark Green/Orange wire. If voltage is 10 volts or more, replace engine controller.
Was this
answer
helpful?
Yes
No
+4
Sunday, March 11th, 2012 AT 8:43 PM
Tiny
FIXITMR
  • EXPERT
Running ok? Could be out of spec injector(s) or wiring/plug/ECM issue.
Was this
answer
helpful?
Yes
No
Sunday, March 11th, 2012 AT 8:50 PM

Please login or register to post a reply.

Related OBD1 Code 27 Content

VIEW MORE

Sponsored links