1985 Chevrolet Silverado LT1 swap fuse box

Tiny
ICESHIP
  • MEMBER
  • 1985 CHEVROLET SILVERADO
  • 5.7L
  • V8
  • 2WD
  • AUTOMATIC
Ok. I have got everything out of the 1995 roadmaster wagon engine and harness with under hood fuse box. How do you wirer the fuse box up. I do know that the harness has its own ground, fuse box get power from battery to fuse box post. Now all the pink wires under the box goes to what. I see the ignition fuse ONE wire going to pcm and larger gage wire witch was cut I would think that it going to to the starter. I may just be over thinking things. Harness is not on engine. Rewiring for swap
Sunday, June 15th, 2014 AT 5:23 AM

3 Replies

Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
That's alittle bit to much for here. As the lt1 is obd 2 and you have an obd1 or less set up
Was this
answer
helpful?
Yes
No
Sunday, June 15th, 2014 AT 8:10 AM
Tiny
WRENCHTECH
  • MECHANIC
  • 20,761 POSTS
I agree with Hmac300.
You're just wasting your time and money. You don't have an operating system for that setup and you could buy a brand new truck for what it would cost to make that work, not to mention it is against federal law to do it anyway.
Was this
answer
helpful?
Yes
No
Sunday, June 15th, 2014 AT 10:08 AM
Tiny
ICESHIP
  • MEMBER
  • 8 POSTS
That is ok. People do these swaps and ls swaps in trucks like mine and older all the time. Thanks for the help I just figured it out, it's not rocket science. It will be in truck by end of the week
Was this
answer
helpful?
Yes
No
Sunday, June 15th, 2014 AT 4:23 PM

Please login or register to post a reply.

Related General Content

GUIDE
Inquire Here