1967 Chevy won't run when warm.

BF11211

MEMBER
1967 CHEVROLET SILVERADO
V8
4WD
MANUAL

I have a 1967 Chevy 1500 fuel port injection that runs great! Until it gets warm, then it still runs. Until you press the gas, then the motor cuts out. Any suggestions? Plugs, plug wires and distributor are all good. Ohh! Also no one seems to be able to read the computer. Any ideas?

Saturday, July 2nd, 2011 AT 7:24 PM

5 Replies

JDL

MECHANIC
16,098 POSTS

I don't think 67 had a factory computer.

Was this

answer

helpful?

Yes

No

Saturday, July 2nd, 2011 AT 8:16 PM

RASMATAZ

MECHANIC
75,992 POSTS

What is it a 67 or 97 truck? When you say the motor cuts out -did you meant it'll stall or bogs down terribly w/o stalling?

Was this

answer

helpful?

Yes

No

Saturday, July 2nd, 2011 AT 9:17 PM

BF11211

MEMBER
3 POSTS

It is the very first year with a computer.
When it warms up it will idle fine, but as soon as you press the gas is spits, sputters, and dies then takes 10-12 mins to start again.

Was this

answer

helpful?

Yes

No

Sunday, July 3rd, 2011 AT 2:12 AM

RASMATAZ

MECHANIC
75,992 POSTS

I'll tell what show us a picture of the computer and will proceed on -A 67 don't have an electronic engine management system unless you're referring to a 76 that has an ECM in the distributor for the ignition system, that's all-Verify the year of the vehicle

Was this

answer

helpful?

Yes

No

Sunday, July 3rd, 2011 AT 2:56 PM

BF11211