06 Mazda Mpv Lx Rear Rotor Removal

2006 MAZDA MPV
3.0L • 6 CYL • 2WD • AUTOMATIC
Avatar
MENA91
  • MEMBER
  • 1 POST
06 Mazda MPV Lx. Trying to remove the rear rotors. Caliper assembly already off. The 2 screws holding the rotor won't budge. Sprayed penetrating fluid and gave a couple whacks with the impact driver. I'm assuming it has to do with the flange bolt? Or..? Any advice would be greatly appreciated.
Dec 27, 2014 at 1:56 PM
Advertisement
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Avatar
HOMER1967
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 875 POSTS
try to alternate direction with the impact driver a few times,in other words try to tighten them a little,then try to loosen them.and keep tapping around the screw with a small hammer.
Dec 27, 2014 at 6:19 PM