Clutch

FORD RANGER
Avatar
LILHOOD
  • MEMBER
  • 1 POST
1996 ford ranger 127,000 2.3L 4 cylinder. I recent replaced the slave cylinder on my truck. The clutch has no resistance and it won't shift gears. Also the brakes are very hard, I was wandering what could be wrong with it?
Oct 8, 2007 at 10:39 AM
Advertisement
Avatar
BOOTDOG
  • CAR REPAIR CONTRIBUTOR
  • 665 POSTS
you gotta bad booster or a vacuum leak for the brake problem. make sure all the air is out of the system when bleeding the slave cylinder.
Oct 8, 2007 at 7:54 PM
Avatar
PEPERDAVE
  • MEMBER
  • 1 POST
I HAVE A 01 RANGER WITH 116k MILES ITS A 4BANGER WITH 5SP MAN TRANS THE PROBLEM IS WHEN THE TEMP CHANGES OUTSIDE MY CLUTCH FLUID LEAKS, BUT ITS NOT AN ALL THE TIME ONLY WHEN IT GOES FROM WARM OUT TO COLD AT NIGHT
Oct 27, 2007 at 10:46 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.