Engine swap

CHEVROLET BLAZER
Avatar
DIGGIDY
  • MEMBER
  • 3 POSTS
I have an 1989 S-10 Blazer with a 4.3, its a 4x4, automatic with 109k miles. It has a bad engine. I found a 4.3 out of a 85 Monte Carlo. What problems will I face tring to put this engine in my truck? Thanks
Jun 23, 2007 at 3:31 PM
Advertisement
Avatar
E40WATER12
  • CAR REPAIR CONTRIBUTOR
  • 522 POSTS
I am sure it will work, With a bit of fab work, Is youre
1989 S-10 Blazer with a 4.3 fuel injected?, How about the 85 monte carlo, Motor fuel injected or carbed?. Well you could use the block from the monte carlo, swap over the intake off youre Blazer, Then u wont have to swap over the wiring harnesses, I would just make sure get things are complete from the monte carlo motor so then u dont have to go to the wreckers to grab parts.

GoodLuck.
Jun 23, 2007 at 5:37 PM
Avatar
DIGGIDY
  • MEMBER
  • 3 POSTS
Thanks for the reply. Im gonna try to do this swap with my brother. Im thinking I should keep the intake, fuel injection, wire harness, and oil pan from the Blazer and everything else should be fine. What about the motor mounts?
Jun 23, 2007 at 7:28 PM
Avatar
E40WATER12
  • CAR REPAIR CONTRIBUTOR
  • 522 POSTS
I would just keep both motor mount from the monte carlo as well, If u need them then u got them.
Jun 26, 2007 at 2:55 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.