ABS light on?

2007 CHEVROLET AVALANCHE
Avatar
KAMRYN STOREY
  • MEMBER
  • 1 POST
I would like to know if it is safe to drive with the ABS light on? Do i need to go in for repair soon or does it matter?
Sep 9, 2009 at 3:32 PM
Advertisement
Avatar
RHALL77
  • CAR REPAIR CONTRIBUTOR
  • 3,361 POSTS
Hello,

What happens on these is the front hubs go out causing the ABS wheel speed sensor to stop working but the be sure here is a guide to help you run the codes.

https://youtu.be/rTtAnsOlZU4

this guide will walk you through the hub replacement

https://youtu.be/ZgiPRG6jffc

Please let us know if you need anything else to get the problem fixed.
Feb 13, 2019 at 7:26 PM (Merged)
Avatar
SFLANAGAN
  • MEMBER
  • 1 POST
2003 Chevy Avalanche ABS light on? Just started today. Am I looking at a high cost fix?
Feb 13, 2019 at 7:26 PM (Merged)
Avatar
FIXITMR
  • CAR REPAIR CONTRIBUTOR
  • 9,990 POSTS
get code read, could just be a wheel sensor issue.
Feb 13, 2019 at 7:26 PM (Merged)
Avatar
SHELDON123
  • MEMBER
  • 1 POST
my abs light came on and wont shift out of 1st gear,replaced the out put sensors,is there an input sensor on the transfer case how many sensors r on the transfer case just wanting to know if there is a input sensor at the front of the transfer case or at the end of the tranny
Feb 13, 2019 at 7:26 PM (Merged)
Avatar
CARADIODOC
  • CAR REPAIR CONTRIBUTOR
  • 34,309 POSTS
What you're describing involves two totally different systems. Speed sensors on a part of the drive train are for shifting and the speedometer. The anti-lock brake system uses a wheel speed sensor at each front wheel, and to save money, GM usually uses just one sensor in the rear to measure both rear wheel speeds together. Unless something has changed, that one sits on top of the differential housing. They did have some older models that used the speed sensor at the rear of the transmission for the anti-lock brake system.

The place to start is not by replacing random parts. Start by reading the diagnostic fault codes, but understand those never say to replace parts. They only indicate the circuit or system that needs further diagnosis, or they describe the unacceptable operating condition. A part referenced in a fault code is only the cause of that code about half of the time. You also have to look at the wiring and connectors.

Most likely you'll have to visit a mechanic to have ABS codes read. Many auto parts stores will read codes for you for free, but they can only read engine codes.
Feb 13, 2019 at 7:26 PM (Merged)
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.