If the R is blinking, there should be a problem there. What scan tool did you use to check codes?

Answered by KHLow2008 (expert)
39,869 answers provided

A snap on scanner with the keys even under transmission codes nothing popped up

Response from alfredm8702
40 questions asked

Under normal circumstances the R indicator light should not be blinking even if a fault had been detected. I believe the Park and Neutral Position switch for the Reverse circuit has a loose connection somewhere or the PCM is the one causing it.

Check the PNP switch wire harness connector for a loose or contaminated connections forst.

Answered by KHLow2008 (expert)
39,869 answers provided

All the connections are fine all the gears work except reverse maybe a bad Tranny?

Response from alfredm8702
40 questions asked

Is possible for the trans to be bad but your vehicle is too new to be having problems. More likely to be control problems.
I would suggest testing the wirings for continuity in circuit and also the PNP switch and PCM.

Answered by KHLow2008 (expert)
39,869 answers provided

Where are the pnp and pcm switches located?

Response from alfredm8702
40 questions asked

And neutral is in gear as well this is weird

Response from alfredm8702
40 questions asked

When gear shift is in N and gears are engaged, either the gear shift cable is out of adjustment or the transmission has internal faults.

Answered by KHLow2008 (expert)
39,869 answers provided