2006 Lexus IS 250 Repair Question
Asked on October 4, 2011
Hi, I recently had the clutch, flywheel and clutch release bearing fitted on my vehicle being a lexus is250 tbis was due to a high biting point and juddering when setting off. Since having the work done i am still suffering from the above problems i hav
Vehicle is manual transmission
Asked by Shabiris250Answer
Replied on October 4, 2011
Sorry computer messed up, had a new clutch flywheel and clutch bearing installed due to high clutch pedal and judder through car
Still have the same problems after install what else can i try?
Thanks
Replied on October 4, 2011
Check the engine mounts and pedal height adjustment.
Replied on October 4, 2011
Judder would be flywheel was it machined? high pedal was pedal height and free play checked?
Replied on October 4, 2011
Is there a pedal height adjustment on this vehicle? Also would the engine mounts only cause judder only on setoff?
Replied on October 4, 2011
New flywheel was a fidanza Solid aluminium so it would have been checked from factory im assuming will check the pedal asap
Replied on October 4, 2011
Have motor mounts checked also like KHL said
Replied on October 4, 2011
Thanks for all your help will get it booked in
Replied on October 7, 2011
Problem solved needed the pedal adjusting thanks again everyonee