2005 Chrysler PT Cruiser Repair Question
Asked on December 2, 2012
Chrysler PT Cruiser Camshaft Problem
I keep getting a p0344 code even though i have changed the camshaft sensor multiple times and all wiring is new, could it be doing this because i dont let the car warm up?
Asked by (pending member)Answer
Replied on December 2, 2012
a code never identifies a bad part just a failed system
Test 1 - 2
Test 3 - 6
Test 7 - 11
Test 12
SYMPTOM
P0344-CAMSHAFT POSITION SENSOR INTERMITTENT
WHEN MONITORED
Engine running or Cranking.
SET CONDITION
When the failure counter reaches 20. One Trip Fault.
POSSIBLE CAUSES
Good trip equal to zero
Wiring harness inspection
(K7) 5 volt supply circuit open or shorted to ground
Tone wheel/pulse ring inspection
Checking CKP signal with the DRBIII(R) lab
Camshaft position sensor
(K44) CMP signal circuit open
(K44) CMP signal circuit short to ground
(K44) CMP signal circuit shorted to B+
(K44) CMP signal circuit short to (K7) 5 volts
PCM
