Engine does not crank. Fuse 107 Constantly Blowing. Replace Ignition Switch. Same Result.

2001 MERCURY SABLE
125,000 MILES
Avatar
CPFULL99
  • MEMBER
  • 5 POSTS
I reviewed the following answer: http://www.2carpros.com/questions/ford-taurus-2000-ford-taurus-electrical-starter-issues-constantly-blowi

I have replaced the ignition switch with the the same result: F107 blows.

Need wiring diagrams for:
Connector C250
Connector C270b
Load side wiring from F107
Oct 2, 2011 at 8:41 PM
Advertisement
Avatar
HMAC300
  • CAR REPAIR CONTRIBUTOR
  • 48,601 POSTS
heres the diagram, if the fuse continues to blow check the starter relay for being bad.also check your grounds make sure they are good. If all else fails smack the starter on the side with a hammer on the housing. if it starts you probably have a bad starter.
Image (Click to enlarge)
Attached Media
Oct 2, 2011 at 10:48 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.