Power steering drops out when rev's drop.

Tiny
LYNBRODERICK
  • MEMBER
  • 2001 FORD GHIA
  • 310,000 MILES
The power steering drops out when you slow down and the rev's drop. As soon as you accelerate it come back. I have replaced a leaking sender and bought and installed a new pump.
Monday, October 8th, 2012 AT 6:06 AM

7 Replies

Tiny
KHLOW2008
  • MECHANIC
  • 41,814 POSTS
Is the pump new, rebuild or used?
Did you clean the reservoir?
Was fluid dirty?
Is belt tension correct?
Was this
answer
helpful?
Yes
No
Monday, October 8th, 2012 AT 10:10 AM
Tiny
LYNBRODERICK
  • MEMBER
  • 4 POSTS
The pump is a rebuild swap, the old was the original. Everything is spotless clean. All new fluid due to a leaking sender which was replaced. Belt tension right. We have checked all the oil lines are not blocked and are cleaned with high pressure air. And bled the lines.
Was this
answer
helpful?
Yes
No
Wednesday, October 10th, 2012 AT 1:46 PM
Tiny
KHLOW2008
  • MECHANIC
  • 41,814 POSTS
You should be testing the pump pressure. The rebuilt pump is the one likely to cause this problem.
Was this
answer
helpful?
Yes
No
Wednesday, October 10th, 2012 AT 2:28 PM
Tiny
LYNBRODERICK
  • MEMBER
  • 4 POSTS
The problem is the same and we have tried a pump that is working perfect in another car. Plus the exchange pump. So that is 3 pumps and the same problem. Do the senders have any connection to the computer elements of the car.
Was this
answer
helpful?
Yes
No
Friday, October 12th, 2012 AT 4:46 AM
Tiny
KHLOW2008
  • MECHANIC
  • 41,814 POSTS
The pressure sensor is linked to the engine computer. Its main function is to signal to the computer that there is additiobnal load on the engine when power steering is turned during idle so that the computer would increase the idling speed if necessary.

If the idling speed drops too low, it means the idling speed is not being compensated by the load produced by the pump working under pressure.

If the idling speed is not stable, it could be due to the idle control system and celaning the throttle body and IAC would help.
Was this
answer
helpful?
Yes
No
Friday, October 12th, 2012 AT 12:53 PM
Tiny
LYNBRODERICK
  • MEMBER
  • 4 POSTS
Thank you for your time. We replaced the whole Rack and the problem is solved. Our son died and I did not get back to you sorry.
Was this
answer
helpful?
Yes
No
Monday, November 19th, 2012 AT 9:59 AM
Tiny
KHLOW2008
  • MECHANIC
  • 41,814 POSTS
Sorry to for the bad news and we would like to extend our condolences.

Thsnk you for the feedback.
Was this
answer
helpful?
Yes
No
Monday, November 19th, 2012 AT 6:32 PM

Please login or register to post a reply.

Sponsored links