WHY ARE THE INJECTOR NOT OPEN UP?
1999 Nissan Maxima
When i am cranking the injector don't open up to let gas into the cylinder i check the injector pulse with a noid light, the light do not blink.
August 25, 2012.
August 25, 2012.
The cam sensor is the primary signal for the fuel injectors. Of course other sensors such as crank needs to be working as well.
Oil is getting into the cam sensor where the wiring fit into it do oil suppose to be in there.
No, the connectors should be dry. If oil is from external, cleaning it up wold be sufficient but if it is leaking from within the connector, the sensor is bad.
Under such circumstances there is no need to test because it is bad causing the non starting. Replacing it is the only option.
Hi hope you can help, this is a general question. 2 wire sensors, crank and cam are referred to as inductive, magnetic, whilst 3 wire sensors are Hall effect. Can a inductive, magnetic ...
3 answers • 2010 All Other Makes All Other Models
I have a 2000 bonneville ssei. It has 2 02 sensors. I get the code that says cat. sys. efficency level low bank 1. Is that the upstream 02 or the downstream 02
1 answer • 2000 Pontiac Bonneville • 150,000 miles
The service manual for my 1996 GMC Sierra tells me that my truck has four oxygen sensors. They are designated: Bank 1 Sensor 1, Bank 1 Sensor 2, Bank 1 Sensor 3, and, Bank 2 Sensor 1. ...
1 answer • 1996 GMC Sierra • 125,000 miles
I had a rough starting when cold issue. Checked the codes and discovered two codes for a lean condition in both banks. After not finding a vac leak, I replaced the MAF with a ...
2 answers • 2002 Chevrolet Silverado • 170,779 miles