HAVE /SPEEDOMETER NOT WORKING AND WILL NOT SHIFT GEARS. CODE READER READS P1698/NO INFORMATION FROM TCM.WOULD RESETTING THE COMPUTER FIX THIS AND HOW DO I RESET THE COMPUTER IN A
1999 Chrysler Intrepid • 180,000 miles
Check engine light came on/ speedometer quit/only moves forward in 1st gear/also no high beam headlights
February 19, 2012.
February 19, 2012.
Page 1 of 1
DTC P1698-A: NO CCD/PCI BUS MESSAGE FROM TCM
For connector terminal ID, see CONNECTOR IDENTIFICATION. For wiring diagram, see WIRING DIAGRAMS article.
Using scan tool, read Diagnostic Trouble Codes (DTCs). If scan tool display STARTS SINCE SET counter is equal to one or less, go to next step. If scan tool STARTS SINCE SET counter is not equal to one or less,
go to step 6.
If BUS is not operational, scan tool will display a message on odometer. If odometer displays NO BUS, perform VEHICLE COMMUNICATIONS TEST 15A in appropriate VEHICLE COMMUNICATIONS
article in ACCESSORIES & EQUIPMENT. If odometer does not display NO BUS, go to next step. If scan tool also displays DTC P1695-A, go to next step. If scan tool does not display DTC P 1695-A,
perform VEHICLE COMMUNICATIONS TEST 12A in appropriate VEHICLE COMMUNICATIONS article in ACCESSORIES & EQUIPMENT.
Turn ignition off. Disconnect Powertrain Control Module (PCM) connector. Using a DVOM, check voltage on PCI BUS circuit at PCM connector terminal No. 59 while turning ignition key to RUN position. See
PCM CONNECTOR WIRE IDENTIFICATION table. Verify voltage reading by turning ignition key more than once. If voltage is .4 volts or less after turning ignition on, go to next step. If voltage is more
than .4 volts after turning ignition on, replace PCM. Perform TEST VER-2A: ROAD TEST VERIFICATION.
Disconnect Body Control Module (BCM) (Bone) 12-pin connector. Using a DVOM, measure resistance of PCI BUS circuit between BCM connector terminal No. 1 and PCM connector terminal No. 59. See BCM
CONNECTOR WIRE IDENTIFICATION table and PCM CONNECTOR WIRE IDENTIFICATION table. If resistance is less than 10 ohms, replace BCM. Perform TEST VER-2A:
ROAD TEST VERIFICATION. If resistance is 10 ohms or more, repair open PCI BUS circuit. Perform TEST VER-2A: ROAD TEST VERIFICATION.
Condition to set trouble code is not present at this time. Inspect all related wiring and connectors and repair as necessary. If no problems were found with wiring and connectors, go to next step. If related wiring and
connectors were repaired, perform TEST VER-2A: ROAD TEST VERIFICATION.
Using scan tool, erase DTCs. Turn ignition off. Turn ignition on and start engine. While monitoring scan tool display, wiggle wiring harness between Transmission Control Module (TCM) and Body Control
Module (BCM). Take vehicle for a short test drive. After test drive, using scan tool, check for DTCs. If BUS DTC is present go to step 1 and perform procedure again. If BUS DTC did not return, see
INACTIVE TROUBLE CODE CONDITION under SELF-DIAGNOSTICS. Test is complete. Perform TEST VER-2A: ROAD TEST VERIFICATION.
BCM CONNECTOR WIRE IDENTIFICATION Application
BCM Terminal No. 1 PCI BUS Circuit
PCM CONNECTOR WIRE IDENTIFICATION Application
PCM Terminal No. 59 PCI BUS Circuit
Feb 19, 2012.
Feb 19, 2012.
The Haynes manual shows a homemade water pump holding tool and since i cant wait for one to be shipped from catalog (no one else carries it)i need the specs to make one
14 answers • 2003 Saturn Ion • 125,000 miles
I'm currently going to college persuing my dream to be an automotive technician. I have started buying tools and I would like to know what tools a real mechanic needs, Im sure there is ...
2 answers • 2002 Pontiac Grand Prix • 13,000 miles
What is the 'correct' tool for removing the gas tank fuel pump fuel connects on a 1999 suburban, 4x4 , k1500. I have tried one by Leslie - can't get it to fit into the coupler, the ...
3 answers • 1999 Chevrolet Suburban • 172,000 miles
Brakes problem 2005 Skoda Fabia 4 cyl Front Wheel Drive Manual 39000 miles Hello, Having extreme hardship locating the tool to press brake piston back into it's housing whilst ...
3 answers • 2005 Skoda Fabia