My car will crank but will not start

1997 CHRYSLER TOWN AND COUNTRY
170,000 MILES
Avatar
EUNJOH
  • MEMBER
  • 1 POST
My car cranks but wont start. There is also no spark. I have already changed the camshaft and crankshaft because my scantool gave me a code of P0340.
Sep 5, 2011 at 11:50 PM
Advertisement
Avatar
RASMATAZ
  • CAR REPAIR CONTRIBUTOR
  • 75,992 POSTS
https://www.2carpros.com/articles/car-cranks-but-wont-start

Get a helper disconnect a sparkplug wire or 2 and ground it to the engine atleast 3/16 away from ground-have helper crank engine over-do you have a snapping blue spark? If so-you have a fuel related problem, Do you hear the fuel pump come On when you turn key on? If not check fuel pump fuse and fuel pump relay if okay-check the fuel pressure to rule out the fuel filter/fuel pump/pressure regulator and listen to the injector/s are they pulsing or hook up a noid light. No snapping blue spark continue to troubleshoot the ignition system-power input to the coil/coil packs,coil's resistances,cap and rotor,distributor pick-up coil, ignition control module, cam and crank sensors and computer Note: If it doesn't apply disregard it and keep testing
Aug 30, 2020 at 12:28 PM
Avatar
JACOBANDNICKOLAS
  • CAR REPAIR CONTRIBUTOR
  • 110,190 POSTS
Hi Neal, do you have the same vehicle as listed above? Also, what size engine does it have?

Also, take a look through this link and let me know if it mirrors what you experience. What you described sounds like a faulty crankshaft position sensor.

https://www.2carpros.com/articles/symptoms-of-a-bad-crankshaft-sensor

If you have a live data scan tool, see if there is an RPM signal while cranking the engine. If there isn't one, this is my first suspect.

Let me know.

Joe
Aug 11, 2022 at 6:46 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.