HOW HARD IS IT TO GET TO AND REPLACE THE #2 O2 SENSOR ON A '97 ?
1997 Cadillac Deville • 82,000 miles
The car is driven very little, as the mileage will indicate. A local parts house read the "service engine soon" light problem and the #2 O2 sensor was what was indicated.
April 14, 2012.
April 14, 2012.
No, I do not have the code. The parts guy showed me the sensor, and said that it is in the rear exhaust manifold. How to get to it is the main question. It must be near it's plug in - since the leads are only about 12" long.
Nope. Other than from the top (nothing really visable past the valce cover). And laying on my side - I can see the Cat converter. But the exhaust coming to it has nothing. Almost has to be in the manifold above that.
Yah it's a bugger. Try getting behind from fender area. Use hand to try and feel it on manifold.
Hi hope you can help, this is a general question. 2 wire sensors, crank and cam are referred to as inductive, magnetic, whilst 3 wire sensors are Hall effect. Can a inductive, magnetic ...
3 answers • 2010 All Other Makes All Other Models
2007 toyota camry 140k. Check engine light code Knock sensor. Reset and came back on right away. What could cause this other than the obviouse bad sensor or wire?
9 answers • 2007 Toyota Camry • 140 miles
I had a rough starting when cold issue. Checked the codes and discovered two codes for a lean condition in both banks. After not finding a vac leak, I replaced the MAF with a ...
2 answers • 2002 Chevrolet Silverado • 170,779 miles
Describe the type sensor of the Knock sensor is on this vehicle and how it should be tested.?
1 answer • 2002 Chrysler 300 • 100 miles