ruff idle and stall

1996 JEEP GRAND CHEROKEE
220,000 MILES
Avatar
BIGKORN
  • MEMBER
  • 1 POST
1996 4.0 jeep grand cherokee replaced ecm camshaft position sensor coil and did a basic tune up finaly got the engine running with the replacement of the camshaft position sensor but now runs ruff and stalls
Jul 28, 2011 at 7:05 AM
Advertisement
Avatar
RASMATAZ
  • CAR REPAIR CONTRIBUTOR
  • 75,992 POSTS
https://www.2carpros.com/articles/engine-misfires-or-runs-rough

1.Defective spark plugs
2.Inadequate spark/coil,defective spark plug wire.
3.Lack of compression
4.False air leakage.
5.Faulty fuel injectors.
6.Insufficient fuel pressure.
7.Contaminated fuel.
8.EGR valve that is leaking.
9.Oxygen sensors.
10.Throttle position sensor.
11.Manifold absolute pressure sensor
12.Mass Airflow Sensor
13.Idle air control valve

Note: If it doesn't apply disregard it-
Jul 28, 2011 at 9:58 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.