Torque Converter

1996 GEO TRACKER
158,000 MILES • 4 CYL • 4WD • AUTOMATIC
Avatar
THMICK37
  • MEMBER
  • 12 POSTS
Changing the motor in my 96 Geo Tracker. How do I get the torque converter off. Any help would be useful.
Aug 5, 2011 at 7:08 PM
Advertisement
Avatar
DOCFIXIT
  • CAR REPAIR CONTRIBUTOR
  • 18,828 POSTS
From trans or off flywheel?
Aug 5, 2011 at 7:15 PM
Avatar
THMICK37
  • MEMBER
  • 12 POSTS
Flywheel
Aug 5, 2011 at 7:19 PM
Avatar
DOCFIXIT
  • CAR REPAIR CONTRIBUTOR
  • 18,828 POSTS
Remove bolts engine side into convertor are three
Aug 5, 2011 at 7:24 PM
Avatar
THMICK37
  • MEMBER
  • 12 POSTS
How do I get to them. Do I have to remove the oil pan? I have already removed the cover plate.
Aug 5, 2011 at 7:33 PM
Avatar
DOCFIXIT
  • CAR REPAIR CONTRIBUTOR
  • 18,828 POSTS
Remove two bolts flexplate inspection cover access there neeed to rotaot convertor
Aug 5, 2011 at 7:36 PM
Avatar
THMICK37
  • MEMBER
  • 12 POSTS
Already did that. Can not get a ratchet or wrench on the bolts.
Aug 5, 2011 at 7:38 PM
Avatar
DOCFIXIT
  • CAR REPAIR CONTRIBUTOR
  • 18,828 POSTS
15 deg offset wrench
Aug 5, 2011 at 7:44 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.