Why would there be a lot of oil in the upper intake manifold?

Tiny
LDZOLLER
  • MEMBER
  • 1996 FORD THUNDERBIRD
  • 12,500 MILES
I removed the throttle body as I want to bore it out and polish it. I looked into the upper intake and there is a lot of oil present. There is also some oil residue on the manifold side of the throttle body plate. Where could this oil be coming from and how do I fix this?
Friday, May 18th, 2012 AT 1:17 AM

5 Replies

Tiny
ASEMASTER6371
  • MECHANIC
  • 52,797 POSTS
Excessive crankcase pressure either from a bad pcv or the rings are worn.

Roy
Was this
answer
helpful?
Yes
No
Friday, May 18th, 2012 AT 1:19 AM
Tiny
LDZOLLER
  • MEMBER
  • 3 POSTS
A compression test would reveal a worn ring, correct?
Was this
answer
helpful?
Yes
No
Friday, May 18th, 2012 AT 1:21 AM
Tiny
ASEMASTER6371
  • MECHANIC
  • 52,797 POSTS
Yes, you must do both wet and dry and the difference cannot be more than 10-15 lb difference.

Roy
Was this
answer
helpful?
Yes
No
Friday, May 18th, 2012 AT 1:23 AM
Tiny
LDZOLLER
  • MEMBER
  • 3 POSTS
Thank you for the quick replies. PCV valve is good, check it tonight. Does the lower intake have a plate on the bottom? I'm just curious as to how the oil makes its way so far up into the upper intake?
Was this
answer
helpful?
Yes
No
Friday, May 18th, 2012 AT 1:28 AM
Tiny
DJCL
  • MECHANIC
  • 767 POSTS
Oil like slime coating in the inside if the intake was a co min problem with the 4.6 v8 engine. When thay got up in milage thay had some blow buy. Worn rings. Thay ran ok like that but would get problems with egr ports cloging up. Run an intake cleaner through it. Like run right.
Was this
answer
helpful?
Yes
No
Friday, May 18th, 2012 AT 1:36 AM

Please login or register to post a reply.

Sponsored links