need help or step by step pictures on how to pull out fan blower motor. on a 1995 cadillac deville 4.9
May 8, 2011 at 9:52 PM
fan blower motor
1995 CADILLAC DEVILLE
BADBOYMARCUS
- MEMBER
- 71 POSTS
- FOLLOW
Advertisement
Disconnect negative battery cable.
Remove cross-tower brace (2 nuts on each side).
Using a utility knife, cut rubber insulator at guide lines and remove metal patch plate beneath.
Remove blower motor wiring harness connector, cooling hose and mounting screws.
Remove blower motor from case.
Installation
Install blower motor fan assembly.
Install blower motor electrical connector, cooling hose and mounting screws.
Install patch plate and seal insulator patch.
Install cowl cross-tower brace (2 nuts on each side).
Install negative battery cable.
Remove cross-tower brace (2 nuts on each side).
Using a utility knife, cut rubber insulator at guide lines and remove metal patch plate beneath.
Remove blower motor wiring harness connector, cooling hose and mounting screws.
Remove blower motor from case.
Installation
Install blower motor fan assembly.
Install blower motor electrical connector, cooling hose and mounting screws.
Install patch plate and seal insulator patch.
Install cowl cross-tower brace (2 nuts on each side).
Install negative battery cable.
May 8, 2011 at 9:59 PM
thanks rasmataz.
May 11, 2011 at 11:33 PM
Use a dloor jack under the front of the subframe and remove both front frame bolts. Lower the subframe to tilt the engine forward, and you can just remove the blower mounting bolts, and the blower motor. You may also have to disconnect the upper torque strut mounts, for more tilt.
May 13, 2011 at 4:41 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.