Remove battery ground cable, then serpentine drive belt and tensioner.
Support vehicle using support fixtures tool Nos. J-28467-A and J-36462, or equivalent.
Raise and support vehicle, then drain engine oil from crankcase.
Remove right side wheel assembly, then right side splash shield.
Remove steering gear pinch bolt. Failure to disconnect intermediate shaft from rack and pinion stub shaft can result in damage to steering gear and/or intermediate shaft.
Remove transaxle mount retaining nut, then engine to frame mount nuts.
Remove front engine mount bracket from block, then outboard flywheel/starter plastic shield.
Remove inboard flywheel metal shield, then start.
Place jack stand under frame front center crossmember, then loosen rear frame bolts. Do not remove rear frame bolts.
Remove front frame bolts, then lower front of frame.
Disconnect DIS sensor wire, then remove oil pan retaining bolts.
Remove oil pan retaining nuts, then oil pan.
Reverse procedure to install. Tighten to specifications.

Answered by ASEMaster6371 (expert)
24,789 answers provided