SPONSORED LINKS

Wont shift while running

Tiny
RNBWBRT
  • MEMBER
  • 1993 DODGE DAKOTA
  • 130,000 MILES
MY 1993 dodge Dakota sport v6 5 speed wont shift while running. Just replaced clutch flywheel and master/slave cylinder What can be wrong when the entire clutch system is brand new?
Thursday, December 1st, 2011 AT 6:03 PM

1 Reply

Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 108,230 POSTS
If it shifts with the engine off, the trans is most likely fine. If it won't shift with the engine running, the clutch isn't disengaging the trans from the engine. Recheck your work. Either the slave isn't properly bled, not properly attached, or something was put together incorrectly when you installed the clutch.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
+1
Thursday, December 1st, 2011 AT 6:12 PM

Please login or register to post a reply.

Related Transmission Clutch Slave Cylinder Replace/Remove Content

Throw out Bearing Replacement
GUIDE
Throw out Bearing Replacement
A throw out bearing is used to apply force against the clutch pressure plate to release the clutch and should be replaced as part of the normal clutch job. It is a good idea...
VIEW MORE

Sponsored links