Removal & Installation

1. Disconnect battery ground. Raise front of vehicle and remove right front wheel assembly. Remove inner fender cover and disc brake cooling duct.
2. Disconnect washer motor and fluid level sensor connectors. Position drain pan under reservoir. Disconnect washer pump tube from pump. Remove bolts and washers securing reservoir. Remove reservoir from
filler neck, drain and remove reservoir. To install, reverse removal procedure. See Fig. 3 .

Answered by hmac300 (expert)
17,879 answers provided

Removing inner fender cover sounds straight forward. What about the brake cooling duct? Thanks

Response from Palmero
2 questions asked

tht shold be pretty straight forward as well, it shold either just twist off or have a few small bolts holding it in place.

Answered by hmac300 (expert)
17,879 answers provided

Thank you very much for your assistance. I will try that this weekend.

Response from Palmero
2 questions asked