2CarPros - Car Questions & Answers

1992 Holden Ute Repair Question


Topics covered: Accumulator, Fire wall, Gas.
Mileage: 24,000 miles.

Asked on May 4, 2012

92 vp ute heater/demister not working.hot air comes to cab but when i operate demister control air does'nt come through vents.

Heater demister problem
Avatar Asked by ellegee

Answer

Replied on May 4, 2012

The bi level control is vacuum operated and often on the older commodores and utes the vacuum switch and or hoses are at fault, listen under the dash drivers side next to console for any hissing noises.

Tiny Answered by mhpautos (expert)
26,900 answers provided
Replied on May 8, 2012

no hissing noises apparent.hoses appear to be connected correctly and in good order.noted that when i remoyed hose connector from switch should there be air emmission.

Tiny Response from ellegee
1 question asked
Replied on May 8, 2012

there should be vacuum, check the hose (small) going through the fire wall and hooking into the inlet manifold at the rear, that is the vacuum supply line.

Tiny Answered by mhpautos (expert)
26,900 answers provided

Replied on May 8, 2012

found a disconnected vacumm hose at front left side of engine,but darned if i can see connection nossle.

Tiny Response from ellegee
1 question asked
Replied on May 8, 2012

Just been re thinking, have a look around the throttle body underneath and at the rear, been a while sine i did a VP, check the length of the hose and see wher it lays around the manifold, i will still try to find the exact port in a manual and re post.

Tiny Answered by mhpautos (expert)
26,900 answers provided
Replied on May 8, 2012

Just had a thought, i think the VP had a vacuum accumulator under the front of the L/H/ guard, so lay the loose vacuum hose along the fire wall and you may find the rest of the hose going to the accumulator, i will check further.

Tiny Answered by mhpautos (expert)
26,900 answers provided

Replied on May 14, 2012

doesn't appear to be anything for this hose to connect to.car is 5.0 ltr v8 model with gas conversion.when blocked hose off i got vaccum to the fitting at the switch fitting,but when i hooked back up still no function of settings.

Tiny Response from ellegee
1 question asked
Replied on May 14, 2012

your in luck, i just had a 5 litre VP booked in for later to day, when it gets here i will have a look at the system.

Tiny Answered by mhpautos (expert)
26,900 answers provided
Replied on May 14, 2012

It just got towed in.... on the L/H side of the fire wall there is a round rubber grommet with one vacuum hose and below that a small pipe (part of the A/C system) the vac hose run along the L/H guard behind the strut tower and it goes to the vac accumulator under the guard, a second vac hose is seen here as well that is the vac line that runs to behind the inlet manifold, problem will be that as this also has gas, all the coolant hoses make it very difficult to see wher it actually goes, i think that this car has a stuffed distributor so if i have to take it out later to day i may see some more ... stay tuned.....

Tiny Answered by mhpautos (expert)
26,900 answers provided