ENGINE STALLS AFTER WARMING UP WONT START UNTIL COOLS DOWN. GIVES CODE FOR O2 SENSOR. VACCUUM? CATALYTIC CONV? BAD O2 SENSOR?
1992 BMW 118d
'92 bmw 525i : It has been running ok but low fuel mileage and exhaust leak. muffler shop tightened exhaust manifold and fixed leak. ran for 1 day then extremely low rough idle and surging as driving and fault code for O2 sensor. I replaced leaking PCV elbow and grommet at brake booster and a cracked air intake tube. Car started and idled perfect but stalls after 5 -10 minutes and wont restart which I assume is when engine is up to or close to operating temp. before replacement of 2 previous mentioned parts, i could keep it running by constant rev or when it surged i could stomp it a couple times and it would regain power. Help please this is an elderly friend's vehicle and she has no money so she is counting on me
October 23, 2011.
October 23, 2011.
Just wondering what sensors i need to replace.codes as follows.p0135,p0155,p0133.two of the codes say bank 1 sensor 1 the other says bank2 sensor 1.I think bank means driver or ...
2 answers • 2002 Dodge Intrepid • 100,500 miles
Hi hope you can help, this is a general question. 2 wire sensors, crank and cam are referred to as inductive, magnetic, whilst 3 wire sensors are Hall effect. Can a inductive, magnetic ...
3 answers • 2010 All Other Makes All Other Models
I had a rough starting when cold issue. Checked the codes and discovered two codes for a lean condition in both banks. After not finding a vac leak, I replaced the MAF with a ...
2 answers • 2002 Chevrolet Silverado • 170,779 miles
Describe the type sensor of the Knock sensor is on this vehicle and how it should be tested.?
1 answer • 2002 Chrysler 300 • 100 miles