HOW DO I INSTALL THE WHEEL CYLINDER ON A S10 PICK UP?
1991 Chevrolet S-10 • 210,000 miles
I need to know how to install the ring clip in the wheel cylinder is their a special tool?
July 24, 2012.
July 24, 2012.
So are you rebuilding it or replacing it?I havent built one in years there so cheap to just buy one not really worth rebuilding them.
No I'm replacing them with Brand New Wheel cylinders. Just need to know how to install them they have a Ring Clip.
Here you go it shows the tool removing it. Says you can use two awls to remove it.
Ok I got the response on installation so I use a 1 1/8 socket and extension but do I hammer it or what?
No problem thats what were here for. Also look next removing the clip I posted how to install it.
Yes thanks I just wanted to know do I use a hammer to tap on the extension bar to make the ring snap on?
2002 Honda Accord mileage: 48,000. Six months ago, my Service Center replaced the front struts on my Accord. They did not say that a wheel alignment was necessary at that time. I now ...
1 answer • 2002 Honda Accord • 48,000 miles
How do I replace rear axle wheel bearings on a 1988 Chevy Suburban 4x4 1500?
1 answer • 1988 Chevrolet Suburban • 150,000 miles
Have a 1998 Ford F150 xlt 4x4-has 134000 miles-I have put a new elec. shift motor on tranfer and also put two new senors on the firewall-but still goes into 4 wheel drive by its self. I...
2 answers • 1998 Ford F-150 • 134,000 miles
This has to do with my 4 wheel drive in 1997 Jeep Cherokee Sport. When in 4 wheel drive it is all over the road and when putback into 2 wheel it clunks and the jeep jumps.
1 answer • 1997 Jeep Cherokee