1990 Nissan truck not running good at all

1990 NISSAN TRUCK

4 CYL • 2WD

KRAZYB_CUSTOMS

MEMBER
1 POST
FOLLOW

I have a 1990 Nissan D21 truck. 2 wheel drive automatic with a 4 cylinder. Truck sometimes starts and dies quickly after. I have already replaced the coil, spark plugs, rotor and cap, drained the fuel and put in new fuel and made sure that the injectors are getting spark. I manually checked the ecu computer and it came out with code 55 which is no malfunction. I have checked and the fuel pump has 35 pounds of pressure and the compression is 115. Any ideas on what else could be causing my problems?

Jul 18, 2011 at 2:01 AM

RASMATAZ

CAR REPAIR CONTRIBUTOR
75,992 POSTS

https://www.2carpros.com/articles/car-cranks-but-wont-start

Get a helper disconnect a sparkplug wire or 2 and ground it to the engine atleast 3/16 away from ground-have helper crank engine over-do you have a snapping blue spark? If so-you have a fuel related problem, Do you hear the fuel pump come On when you turn key on? If not check fuel pump fuse and fuel pump relay if okay-check the fuel pressure to rule out the fuel filter/fuel pump/pressure regulator and listen to the injector/s are they pulsing or hook up a noid light. No snapping blue spark continue to troubleshoot the ignition system-power input to the coil/coil packs,coil's resistances,cap and rotor,distributor pick-up coil, ignition control module, cam and crank sensors and computer Note: If it doesn't apply disregard it and keep testing

If both fuel and spark is present-check the valve and ignition timing, this will lead you to problems
with compression and valves opening and closing at the wrong time/broken or jumped timing
belt/chain.

Jul 18, 2011 at 7:59 AM

Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.