How to change ignition switch
Jan 19, 2013 at 11:02 PM
1988 Honda Accord Change Ignition Switch
1988 HONDA ACCORD
ANONYMOUS
- MEMBER
- 1 POST
- FOLLOW
Advertisement
Remove the lower steering column cover.
Disconnect the ignition switch connector.
Insert key and place in the ``LOCK'' or ``O'' position.
Remove two switch set screws, then the switch.
Reverse procedure to install.
Disconnect the ignition switch connector.
Insert key and place in the ``LOCK'' or ``O'' position.
Remove two switch set screws, then the switch.
Reverse procedure to install.
Jan 20, 2013 at 1:44 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.