1969 Chevrolet Impala Remove Ignition Switch

1969 CHEVROLET IMPALA
Avatar
SHUISS0469
  • MEMBER
  • 2 POSTS
Remove an ignition switch.
Apr 6, 2013 at 10:35 AM
Advertisement
Avatar
ASEMASTER6371
  • CAR REPAIR CONTRIBUTOR
  • 52,796 POSTS
dash mounted or column??

Roy
Apr 6, 2013 at 11:12 AM
Avatar
SHUISS0469
  • MEMBER
  • 2 POSTS
column
Apr 6, 2013 at 11:55 AM
Avatar
ASEMASTER6371
  • CAR REPAIR CONTRIBUTOR
  • 52,796 POSTS
steering whell has to be removed. turn signal switch removed and the lock pin for the cylinder will be exposed.

Roy
Apr 6, 2013 at 12:56 PM
Avatar
SHUISS0469
  • MEMBER
  • 2 POSTS
removed all that, plus the 2 black plates, removed the screws for the top half of the steering column that houses the ignition swith. But the gears are holding the column piece that has the switch in it. Can't remove the switch.
Apr 6, 2013 at 3:30 PM
Avatar
ASEMASTER6371
  • CAR REPAIR CONTRIBUTOR
  • 52,796 POSTS
switch is down below on the column. it is held by 2 little screws and there is a rod that comes up to the cylinder

roy
Apr 6, 2013 at 3:54 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.