NISSAN HARDBODY COMPUTER

Found 5 results

Select a filter to limit the results

Limp Mode - Reduced Power Location Replace/Remove

PCM/ECM Pin Location

Need Pin Location On Pcm/ecm For Circuit Numbers 47/48 And To Include Wire Color.

Asked by pacificislander ·

6 ANSWERS

3 IMAGES

1997

NISSAN HARDBODY

Computer

A car's computer or PCM - ECM (powertrain control module - engine control module) is designed to read various sensors such as the crankshaft position sensor to deliver...

ECM Pin Outs

Trying To See Whether I Can Use This Ecm For My Truck Listed Above.

Asked by pacificislander ·

5 ANSWERS

2 IMAGES

1996

NISSAN HARDBODY

Does Control Module Have To Be Reset When Replaced

Replaced Control Module On 94 Nissan Pickjup Now It Cannot Get It Timed So It Has Any Power

Asked by toshak ·

4 ANSWERS

1994

NISSAN HARDBODY

1990 Nissan Hardbody ECU Ground Points

Hello, We Just Purchased A 1990 Nissan Hardbody And It Has Issues With Not Starting After Running For Awhile (no Set Amounts Of Time...

Asked by poohbearb4u ·

1 ANSWER

1990

NISSAN HARDBODY

Bogs On Acceleration

Truck Will Run Fine One Minute Then The Next It Like Kicks Over In Limp Mode Has A Big When You Are In The Throttle And Will Barely Make It...

Asked by Jwillen96 ·

1 ANSWER

1991

NISSAN HARDBODY

Ask a new Nissan Hardbody question

Sponsored links

Ask a Car Question. It's Free!

SPONSORED LINKS

Online car repair manuals

Online car repair manuals

© 1999 - 2024 2CarPros, Inc.