1988 Volvo 240

1988 VOLVO 240
Avatar
LITTERAL
  • MEMBER
  • 3 POSTS
1988 Volvo 240 4 cyl Two Wheel Drive Automatic

We replaced the pick-up module in the distributor, checked the coil, all of the grounds, engine compartment, and under the dash. Was wondering if there is a relay somewhere?....because there still isn't spark coming out of the coil. We got power in, but nothing coming out of coil.
Sep 28, 2010 at 9:47 PM
Advertisement
Avatar
RASMATAZ
  • CAR REPAIR CONTRIBUTOR
  • 75,992 POSTS
Did we check the ignition control module and the crankshaft position sensor-
Sep 29, 2010 at 5:27 AM
Avatar
LITTERAL
  • MEMBER
  • 3 POSTS
We didn't see a crankshaft position sensor. (Is there one? If so, then where is it?) - just put a new ignition control module in, and its doin the same thing- runs like a dead top.
Sep 29, 2010 at 4:30 PM
Avatar
RASMATAZ
  • CAR REPAIR CONTRIBUTOR
  • 75,992 POSTS
Disregard the CPS Alldata says it has one and Mit1 says it don't come with it-
Sep 29, 2010 at 5:35 PM
Avatar
LITTERAL
  • MEMBER
  • 3 POSTS
Thank you for your help and suggestions, we're open for any other info. Can ya think of anything else?
Sep 30, 2010 at 7:43 PM
Avatar
RASMATAZ
  • CAR REPAIR CONTRIBUTOR
  • 75,992 POSTS
Check the power stage item no.133


https://images.2carpros.com/forum/automotive_pictures/12900_power_stage_1.jpg

Oct 1, 2010 at 3:34 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.