2001 Saturn L300 Help! Left my car running till it ran out

2001 SATURN L300
Avatar
DLL0211
  • MEMBER
  • 2 POSTS
2001 Saturn L300 87000 miles

Left my car running till it ran out of gas and killed the battery and now after adding gas and recharging the battery the car won't turn over and start. Suggestions? We now can hear the whine of the injector, but it won't turn ove.
Oct 31, 2009 at 10:35 PM
Advertisement
Avatar
SATURNTECH9
  • CAR REPAIR CONTRIBUTOR
  • 30,869 POSTS
U probably have a bad battery ur battery was probably weak and u let it so drained that it won't hold enough power to start ur car.have u tried jump starting ur car it might not even jump start if the battery is that bad.start with that but get ur battery tested also make sure ur cables are clean and tight.also donations and feedback greatly appreachiated.
Louie
Nov 7, 2009 at 4:59 PM
Avatar
BLUELIGHTNIN6
  • CAR REPAIR CONTRIBUTOR
  • 16,542 POSTS
is it trying to start or are you just getting a click? if it's trying to start, you will need to cycle the key from off to on WITHOUT CRANKING several times. this will get fuel pressure built back up in the system and help the engine start. if this doesn't work, follow previous poster's response by checking battery and cables .
Nov 7, 2009 at 5:01 PM
Avatar
DLL0211
  • MEMBER
  • 2 POSTS
Turned out to have a major clog in the fuel line - and after the mechanic had to try numerous times to get it re-primed; they were able to start it and blow out all the black smoke and crap that was built up. Runs like a charm again after 50 bucks. I am grateful it wasn't worse! Thanks, though for responding!
Nov 8, 2009 at 1:36 AM
Avatar
SATURNTECH9
  • CAR REPAIR CONTRIBUTOR
  • 30,869 POSTS
I thought it wouldn't turn over so was the fuel line clogged or was it just flooded if u had to clear out all the black smoke then sounds like it was getting fuel u just flooded it.
Louie
Nov 8, 2009 at 11:05 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.