1997 Jeep Cherokee Catalytic converter/O2 sensor

1997 JEEP CHEROKEE
180,000 MILES • 6 CYL • 4WD • AUTOMATIC
Avatar
PBODY26
  • MEMBER
  • 1 POST
I removed the catalytic converter and cut the wires to O2 sensor. Engine is running bad. How do I trick the computer so that it runs better?
Mar 8, 2010 at 7:10 PM
Advertisement
Avatar
CJ MEDEVAC
  • CAR REPAIR CONTRIBUTOR
  • 11,004 POSTS
See my profile..........If I were going to make a WILD AS GUESS......I would probably attempt running the cut wiring, up to the existing upstream O2 sensor, and hooking the SENDER wire to the existing sensor sender wire......if the missing one was a heated sensor, leave those wires out of the equation. Like I said at 1st, W.A.G........hang around see if somebody SHOOTS me down. NO WARRANTY AT TURDDOG-R-US

Love, Turddog
Mar 8, 2010 at 8:08 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.