1991 Honda Accord clutch and slave cylinder

1991 HONDA ACCORD
Avatar
BRYANWESTFALL
  • MEMBER
  • 1 POST
Engine Mechanical problem
1991 Honda Accord 4 cyl Two Wheel Drive Manual

i recently replaced the clutch slave and master cylinder on my honda but i still have no pressure on the pedal after bleeding not sure if i am doing something wrong or this may be an additional problem please help.
Feb 18, 2010 at 4:26 PM
Advertisement
Avatar
RASMATAZ
  • CAR REPAIR CONTRIBUTOR
  • 75,992 POSTS
You've replaced the slave and clutch master cyl . You bleed the clutch the same way you bleed the brakes. Proper bleeding and no pressure best check again the clutch master cylinder could be leaking internally
Feb 18, 2010 at 4:33 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.