1996 Ford Ranger

1996 FORD RANGER

115,000 MILES • 4 CYL • 2WD • MANUAL

JAMESHIXSON

MEMBER
1 POST
FOLLOW

truck is running rough and surging, check engine light came on, reads code p0320. What does this code refer to? Ford book says PIP imput circuit malfunction. Is this the Camshaft position sensor, crankshaft position sensor, or could it be something else?

Thanks

Jim

Oct 5, 2008 at 2:07 AM

MERLIN2021

CAR REPAIR CONTRIBUTOR
17,250 POSTS

Continuous Memory DTC P0320 This code indicates that (2) successive erratic Profile Ignition Pulses (PIP) have occurred. Possible causes are as follows:

Loose wires and/or connectors.
Short circuit to ground in ignition secondary system.
Incorrect 2-way radio installation.

If any of the specified causes were present, repair or replace as necessary.

Oct 5, 2008 at 5:37 AM

Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.