1986 Ford Bronco Wont start

1986 FORD BRONCO

130,000 MILES • V8 • 4WD • AUTOMATIC

MONTANACHAD

MEMBER
2 POSTS
FOLLOW

I have a 1986 Ford Bronco with a 302. I have replaced the Cap and Rotor, The Selonoid, Fuel pump and the Coil. And I still can not get it to run. It turns over fine but wont start what else can I do?

Aug 29, 2008 at 10:50 AM

BLACKOP555

CAR REPAIR CONTRIBUTOR
10,386 POSTS

get a spark teser and check for spark on each cylinder.

its to early to condemn the ignition system but im leaning towards it. get the results back to me first.

you getting good fuel pressure?

Aug 29, 2008 at 1:51 PM

MONTANACHAD

MEMBER
2 POSTS

Thanks for your insight on this matter, I will try the spark plug tester. And I get good fuel pressure out of the fuel pump but I was told at one time I may have two a High and a Low. One may be in the tank.?. If this is an ignition problem then is there any troubleshooting I can do? You guys rock!

Aug 29, 2008 at 2:11 PM

BLACKOP555

CAR REPAIR CONTRIBUTOR
10,386 POSTS

if you have two thers a low pressure in the tank, and the high pressure is under on the frame before the fuel filter.

the troubleshooting im giving you will decide what is wrong, quite simple to do but we have to wait on the results first.

Aug 29, 2008 at 9:18 PM

Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.