I replaced the plugs wires rotor cap coil. Car will not start.
It started just fine before
Jul 24, 2009 at 5:00 PM
Advertisement
DONALDGOLDSR
MEMBER
38 POSTS
I'm assuming you've already doublechecked all your work. Take a close look at the plug wires, make sure they are in the right order.
Also, make sure the rotor is firmly seated in the distributor.
Also, check the elec plugs to the distributor and control module are seated.
Aug 1, 2009 at 10:18 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.