Chevy S-10 98 135,000 4 cyl STD - starting problem

2010 CHEVROLET S-10

TOMGANO

MEMBER
2 POSTS
FOLLOW

Clutch Switch I believe but where is it and how do I replace it?

Stopped. Went to restart and it would not turn over. Cluch was all the way to the floor, no noise so I don't think that it is the starter.
I pushed it and it started by compression and runs fine.

Jun 9, 2007 at 1:12 PM

YABADOO

MEMBER
1 POST

[quote:24f9c4beda="tomgano"]Clutch Switch I believe but where is it and how do I replace it?

Stopped. Went to restart and it would not turn over. Cluch was all the way to the floor, no noise so I don't think that it is the starter.
I pushed it and it started by compression and runs fine.[/quote:24f9c4beda] i have the same problem with a 99 2.0 s10 every thing works but the starter and fuel pump

Aug 7, 2007 at 8:53 PM

Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.