1994 Chevy S-10 ABS light

1994 CHEVROLET S-10
195,000 MILES • 6 CYL • 4WD • AUTOMATIC
Avatar
MRGULFSTREAM
  • MEMBER
  • 1 POST
I have just had new tires put on my blazer. I also had the brake pads replaced. The tire store checked and said that only the front pads needed to be replaced and that the back pads were fine.
The ABS light was on before I had the tires and brake pads replaced. The light is constantly on. I asked the tire store and they said that there could be a fuse that needs to be replaced. Is there sensors located on each of the wheels inside next to the pads? Please help me this was my husband's car and he loved it. I am a widow and need your help.
May 20, 2010 at 2:11 AM
Advertisement
Avatar
RASMATAZ
  • CAR REPAIR CONTRIBUTOR
  • 75,992 POSTS
There's two at the front tires

Raise and support vehicle, then remove wheel and tire assembly.
Disconnect brake caliper assembly and position aside.
Remove rotor, then hub and bearing assembly.
Disconnect wheel sensor electrical connector
Remove sensor wire form upper control arm clip.
Remove sensor and splash shield assembly attaching bolts, then remove sensor.
Reverse procedure to install.
May 20, 2010 at 2:22 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.