1995 Chevy Beretta 95 Beretta won't start

1995 CHEVROLET BERETTA
Avatar
ARICE1046
  • MEMBER
  • 1 POST
1995 Chevy Beretta 4 cyl Two Wheel Drive Automatic

95 beretta stalled while driving. Cranks but won't fire. Sprayed ether into air intake and still wouldn't start. Seemed like spark plugs were not getting spark so replaced coil. Still wouldn't start. Starter Bendix is working fine, fuel pump is working. After 4 days of sitting, started for 2 minutes, stalled out again and wouldn't start. Please help!
Apr 4, 2010 at 9:32 AM
Advertisement
Avatar
HMAC300
  • CAR REPAIR CONTRIBUTOR
  • 48,601 POSTS
get it scanned for codes as there may be an intermittent one. Then check the crank sensor for ohoms as it may be to high preventing your car from starting or the coils getting there data from the circuit board.
Apr 8, 2010 at 5:36 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.